Strong SRT 7010 - Page 23

19
7.3.2 DB Management
This menu allows you to save and reload the channel Data Base of your receiver from/to a USB-device.
This very convenient feature enables you to save your personal settings like Channel-, Favourite-,
Sat- and TP-lists on an USB storage device and load them back to the receiver later. This feature
is especially helpful after unintentional changes or factory reset. In such cases just skip the First
Installation by pressing  in Installation guide and select the DB management menu.
Connect the USB storage device to your receiver and select one of the options:
7.3.2.1 Load from USB
Press OK for displaying the list with available DB les (if any stored before). The DB les
„HB_DATABASE_DDMM.DBM” are shown with their built date (day and month). Select the DB le you
want to load and conrm it with OK. When the DB has been successfully loaded (message appears on
screen) the receiver will switch automatically to the rst stored channel and show its content in the
background. Press  until the OSD menu disappears.
7.3.2.2 Backup to USB
Press OK to make a backup of the data base. A DBM le „HB_DATABASE_DDMM.DBM” with the
current date (day and month), will be created on the USB device. When the DB has been successfully
stored a message will be displayed on screen. Press  until the OSD menu disappears.
7.3.2.3 SatCR
If a SatCR LNB is used, please refer to the manual of that LNB to obtain the technical data about User
Bands numbers and corresponding frequencies.
Note: SatCR can only work in combination with an optional multi-output (max.
8) satellite splitter and a SatCR LNB, example STRONG type SRT L780 (max.
4 users). Note: SatCR cannot be combined with any other DiSEqC function.
SatCR systems are mainly installed by professional experts.
SatCR A Select SatCR A with p/q and OK, if you only use one SatCR LNB.
SatCR B When using a two satellite SatCR system, select also the 2nd LNB and setup as
described below.
System Automatic select: Pre-programmed User Bands are installed, refer to the
manual of your LNB to know which system is supported by the LNB.
IF Channel Manual select: Select the User band ID number according to the
specications of your SatCR LNB. Note: Any SatCR LNB user in the chain
needs a dierent Channel ID number.
Center Freq Manual select: Select the Centre Frequency according to the specications of
your SatCR LNB, corresponding with the correct IF Channel. Note: Any SatCR
LNB user in the chain needs a dierent Centre Frequency.
Press  to store.