Strong SRT 7030 - Page 20

To set the East Limit, use tu to select East Limit, then press shortly u to
move the dish East. Press u again or OK when the limit is reached.
Press OK again. A pop-up message will conrm: East Limit is set.
To disable the limits, select Disable Limit, then Limit Setup and press OK. A pop-up message will conrm:
Disable Limit is set.
When all settings have been made, press  to save the data and leave the window.
7.1.3 SatCR
SatCR LNB's are used for SatCR systems, mainly in apartment blocks. Enter the IF channel number
according the assigned (user band), then the corresponding Centre Frequency. If the system only
supports one satellite, sat position is 1. The version of SatCR is either 1.0 or 2.0. Version 1.0 can have up to
8 dierent users, version 2.0 can have up to 32, it depends on the LNB and splitter used. SatCR systems
are usually installed by professional experts. An optional satellite splitter is required for multi-users.
For SatCR use, DiSEqC and polarity should be disabled.
If a SatCR LNB is used, please refer to the manual of that LNB to obtain the technical data about User
Bands numbers and corresponding frequencies.
NOTE: SatCR can only work in combination with an optional multi-output satellite
splitter and a SatCR LNB, example STRONG type SRT L780 (max. 4 users).
Note: SatCR cannot be combined with any other DiSEqC function. SatCR
systems are mainly installed by professional experts.
IF Channel Manual select: Select the User band ID number according to the specications
of your SatCR LNB. NOTE: Any SatCR LNB user in the chain needs a dierent
Channel ID number.
Centre Freq Manual select: Select the Centre Frequency according to the specications of
your SatCR LNB, corresponding with the correct IF Channel. NOTE: Any SatCR
LNB user in the chain needs a dierent Centre Frequency.
Sat Position Select the number assigned to the satellite by the installer. If you only use only
one SatCR LNB, (for one satellite) then the number is 1.
Version The version of SatCR is either 1.0 or 2.0. Version 1.0 can have up to 8 dierent
users, version 2.0 can have up to 32, it depends on the LNB and signal splitter
used.
Select SAVE to store the settings.
7.1.4 Single satellite search
To search just one satellite, selected before in the Satellite List.
Satellite: Select a satellite with tu to be scanned. You may have selected more than
one satellite in the satellite list.
FTA Only: Press tu to select No to search for scrambled and free channels or Yes to
search for Free to Air channels only.
NOTE: Scrambled channels can not be watched with this receiver.
16