AD Volume Oset Set the balance of volume the AD audio track will have, mixed with the
original audio track.
PVR Storage Information
This item can only be accessed when a suitable USB device is connected.
Find technical details about your USB device, like Total Size, Free Size, Record Size, Time Shift Size and File
System. Use YELLOW (Format) button to format your device in FAT (FAT32). Use BLUE (DVR Set) to set the
options for recording (REC) and Timeshift (TMS). Options are REC+TMS, Record only or Timeshift only.
Format* A (new) USB device must have been formatted before the rst use. The correct format for the
receiver is FAT(32)
WARNING: The format function will delete all data and information from your USB
device or selected partition. STRONG will not take any responsibility for
damaged or lost data on the USB device.
An attention banner will now be displayed. Select OK to start formatting (or to cancel it). The format
procedure will take some time, depending on the size of the used storage device. At the end of the
process, the “Wait” pop-up will disappear. Press to exit the menu.
PVR Setting
This item can only be accessed when a suitable USB device is connected.
Select the options for Timeshift and recording.
Timeshift Timeshift can be disabled here also if needed.
Timeshift to Record If Timeshift was activated, but you decide not to continue watching at this
moment, then press 4 to instant record the rest of the program. If this option
is set to On, the already time shifted part of the program will be added
upfront of the recording, to view later in one go.
On If you suddenly decide to record the program manually, the amount of
recording of a channel you were watching, will be added to a recording, so
you will end up with a recording of the whole program, from the beginning
when you started to watch the channel.
O The above will not happen, a record of a channel will only be saved from the
moment you start the record manually.
Record to Timeshift If set to On, and you have started timeshift already, then decide to record and
watch the program later, the timeshift part of the program will be added to
the recording, so the complete recording will include the time shifted part up
front.
Auto Standby This feature is implemented for power saving. The receiver will turn to
Standby automatically if no command from the remote is received for the
selected time period. Default is 3 hours. It can also be turned O.NOTE: If
there are timers running, the auto standby function will be disabled for the
booked time.
Tools
This menu provides some technical options for the working of the unit.
Information Read the technical details of your receiver, like model number, Software/
Hardware version and serial number. This information could be asked during
a service call or repair request.
26
To Next Page
Loading...
