Stryker M-1 - Attaching an Oxygen Bottle to the Holder

English
EN
www.stryker.com 6100-109-005 REV B 1-29
Operation
Positioning the optional three-stage IV pole (Continued)
A
B
C
D
E
F
A
B
E
D
C
F
Figure 1-23: IV pole raised position
Attaching an oxygen bottle to the oxygen bottle holder
CAUTION
• Do not load the oxygen bottle holder above the safe working load of 15 lb (6.8 kg).
• Do not use two oxygen bottle holders at the same time.
To attach an oxygen bottle to the oxygen bottle holder:
1. Place an oxygen bottle in the holder.
2. Insert the lower strap through the buckle and affix the strap onto itself to secure the oxygen bottle to the holder.
Notes
• Do not use the oxygen bottle holder to hold an oxygen bottle holder when the transport vehicle is in motion. Always
place the oxygen bottle holder in an appropriate storage location when the transport vehicle is in motion.
• Inspect the straps and clips for wear between use. Replace the strap if it no longer holds the oxygen bottle.