EasyManuals Logo

Stryker MX-PRO R3 Operation Manual

Stryker MX-PRO R3
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
To release a wheel lock, press down on the top of the pedal with your foot or lift up on the pedal with your toe. The top of the
pedal will rest against the caster frame when you release the wheel lock.
NNoottee -- Wheel locks help prevent the product from rolling while unattended. Wheel locks may not provide sufficient
resistance on all surfaces or under loads.
RRoolllliinngg tthhee ccoott wwiitthh aa ppaattiieenntt
WWAARRNNIINNGG -- Do not operate the product with the breakaway head section lowered to avoid injury to the patient or operator
or damage to the product. Use only positions 5-7 with this configuration.
1. Make sure all the restraint straps are secure and buckled around the patient (
Securing the patient with restraint straps
(page 18)).
2. Place the product in positions 2-7 for rolling (
Cot positions
(page 15)).
3. When rolling the product, position an operator at the foot end and one at the head end at all times.
NNoottee
Loose items or debris on the patient compartment floor can interfere with the operation of the safety hook and cot
fastener. Keep the patient compartment floor clear.
The product can be loaded with the siderails down only if the restraint belts are buckled around the patient.
SSeeccuurriinngg tthhee ppaattiieenntt wwiitthh rreessttrraaiinntt ssttrraappss
WWAARRNNIINNGG -- Always use all restraint straps to secure the patient on the product. An unrestrained patient may fall from the
product and be injured.
Restraint strap attachment locations should provide strong anchorage and proper restraint position. Do not allow restraint
straps to interfere with equipment or accessories. Buckle all restraint straps when the cot is not in use to avoid damage to
the buckles and straps.
FFiigguurree 77 RReessttrraaiinntt ssttrraappss
Buckle the restraint straps across the patient’s chest/shoulders, waist, and legs (Figure 7).
Wrap the strap around the cot frame and back through the loop on the end of the strap (Figure 8 and Figure 9). The arrows
indicate alternate attachment areas.
EN 18 6082-209-001 Rev AA.3

Table of Contents

Other manuals for Stryker MX-PRO R3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stryker MX-PRO R3 and is the answer not in the manual?

Stryker MX-PRO R3 Specifications

General IconGeneral
BrandStryker
ModelMX-PRO R3
CategoryMedical Equipment
LanguageEnglish

Related product manuals