EasyManuals Logo

Stryker MX-PRO R3 Operation Manual

Stryker MX-PRO R3
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
FFiigguurree 1122 SShhoorrtteenn tthhee rreessttrraaiinntt
NNoottee
When you buckle a restraint strap around a patient, secure the latch plate and remove any loose webbing from the cot.
Inspect the restraint straps at least once a month (more if used often). Check for a bent or broken receiver or latch plate,
or torn or frayed webbing. Replace any worn or inoperable restraint strap.
AAddddiinngg aa rreessttrraaiinntt ssttrraapp eexxtteennssiioonn
Add a restraint strap extension (6082-160-050) for extra length when you buckle the lap belt around larger patients.
FFiigguurree 1133 RReessttrraaiinntt ssttrraapp eexxtteennssiioonn
SSeeccuurriinngg tthhee ppaattiieenntt wwiitthh tthhee PPeeddii--MMaattee®® iinnffaanntt rreessttrraaiinntt ssyysstteemm
WWAARRNNIINNGG -- Always locate the buckle away from obstructions or accessories on the cot to avoid the risk of accidental
release of PPeeddii--MMaattee® infant restraint system and injury to the infant.
To secure the patient with the PPeeddii--MMaattee® infant restraint system:
1. Remove any restraints from the cot.
2. Raise the cot backrest to the full upright position.
3. Position the PPeeddii--MMaattee® pad flat on the cot backrest with the black backrest straps facing out.
4. Wrap the straps around the cot backrest and insert the ends of the straps through the brackets.
5. Fasten the buckle.
6. Pull on the end of the adjustable backrest strap to tighten.
7. Insert the mainframe straps between the product frame and the mattress.
8. Insert the buckle behind the litter cross brace and bring it up in front of the litter cross brace.
9. Fasten the buckle around the litter cross brace. Leave slack in the strap for final adjustment.
10.Tighten all straps.
NNoottee -- For more information about the PPeeddii--MMaattee® infant restraint system, see the manufacturer’s instructions for use,
operation, and care. Safe and proper use of the PPeeddii--MMaattee® infant restraint system is at the discretion of the user. Set
methods and procedures to educate and train your staff on the safe operation or maintenance of this product. These are
general instructions only. Keep these instructions for future reference. These instructions are a permanent part of the
product and should remain with the product even if the product is sold.
PPeeddii--MMaattee® is a registered trademark of Ferno Washington, Inc.
EN 20 6082-209-001 Rev AA.3

Table of Contents

Other manuals for Stryker MX-PRO R3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stryker MX-PRO R3 and is the answer not in the manual?

Stryker MX-PRO R3 Specifications

General IconGeneral
BrandStryker
ModelMX-PRO R3
CategoryMedical Equipment
LanguageEnglish

Related product manuals