The producing company declines any responsibility in case of improper use of the appliance.
The installation must be performed by a qualified technician.
For any technical problem and any request for assistance or intervention, please take contact with
your authorized dealer or service center only. The necessary information for the dealer or for the
service center are on the CE plate.
8. Installation
Once the device is unpacked, place it in the final spot: the freshest and most ventilated area in the room
guarantee the best performance and lower energy consumption, because the refrigerating system is less
stressed.
You must verify the refrigerator leveling and the door alignment, by checking the feet height if necessary.
Check the accessibility of the electric socket.
Take off the coating PVC film inside and outside the device.
The appliance must use an electric socket equipped with an automatic cut-out, respecting the safety
regulations.
The system earthing is mandatory.
In case the device is kept not in operation for a long time, unplug it from the electric socket.
8.1. Positioning
The installer must verify the presence of fire prevention regulations, and place the appliance in full obedience
of the industrial injuries legislation and the current regulations.
The appliance works with an air condenser, so it is necessary to pay attention to the placing, keeping free
the side of the incoming of the cooling air.
Besides, it is also necessary to keep it at least at 20 cm from wall or other appliances nearby the air exit, so
as to obtain the best performances.
Do not place the device in narrow or poorly ventilated spaces, do not expose it directly to sun-beams and
heat sources.
8.2 Ambient
Generally, the refrigerators with air condensing units work with a maximum ambient temperature of 30°C.
The declared performances are not guaranteed with higher temperatures.
Note
To correctly install the device:
- Verify the electrical connections
- Verify the absorption at working device
- Turn the refrigerator on and let it reach the desired temperature before filling it with foodstuff.
If the device has been transported in a non-appropriate way (i.g. non-vertical position or laying on the back),
wait at least 4 hour before switching it on.
The final user must be informed on the right use of the device.
8.3 Cleaning and maintenance
Everyday cleaning and maintenance can be performed by non-specialized staff, only by strictly following the
instructions hereafter.
Before starting any operation, unplug the device!
Wash the internal part with water and neutral detergents, without water jets or abrasive materials. Then, dry
accurately the grids and place them back (do this operation at least every 6 months).
Periodically clean also the condenser, using a brush or a vacuum cleaner: unplug the device before it and be
careful not to bend the aluminum wings.
ATTENTION!!!! The condenser has sharp extremities, make sure to wear protective gloves during the
cleaning operations.
The products inside the refrigerator must be placed on the grids, without going beyond the border, in order to
ensure the best air flow.
In order to perform a correct maintenance of the device, the user, the technician or the staff must, first of all,
keep in mind the elementary safety measures. It is also mandatory not to remove safety devices and
protections during everyday maintenance.
THE MANUFACTURER DECLINES EVERY RESPONSIBILITY FOR DAMAGES OR INCIDENTS
CAUSED BY THE NON-COMPLIANCE WITH THE HERE ABOVE OBLIGATIONS.
Keeping in mind the previous rules, you should clean the cell daily in order to have the best performance
To Next Page
Loading...