Sub-Zero 400 Series Service & Parts Manual

TROUBLESHOOTING GUIDE
5-9
700 SERIES DOOR CLOSING
CHECK AND REPAIR
PROCEDURES
TOP DOOR HINGE:
1: Open door approximately 1", then let door go
to see if it closes on its own. Repeat this
three times.
2: If door fails to close, remove the top hinge
cover from the top hinge arm, and remove the
one top door hinge screw closest to the pivot
point of the hinge. Then loosen the three
remaining top door hinge screws almost all
the way out.
3: Open door approximately 1", then let door go
to see if it closes on its own. Repeat this
three times.
4: If door closes all three times, install 700 Series
Top Hinge Shims Package, part #4202290.
5: If door fails to close, remove the three remaining
screws from the top door hinge and check the
closing action of the hinge on its own. If it
seems week, replace it.
BOTTOM DOOR HINGE:
1: Open door approximately 1", then let door go to
see if it closes on its own. Repeat this three
times.
2: If door fails to close, remove the bottom hinge
cover from the bottom hinge arm, and remove all
bottom door hinge screws. Then check the clos-
ing action of the hinge on its own. If it seems
week, replace it.

Sub-Zero 400 Series Specifications

General

Brand	Sub-Zero
Model	400 Series
Category	Refrigerator
Language	English