EasyManua.ls Logo

Subaru 2011 Forester - Current Fuel Consumption (if Equipped); Average Fuel Consumption; To Turn off Fuel Consumption Indicator Display

Subaru 2011 Forester
446 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (142,1)
Model "A8160BE-B" EDITED: 2010/ 10/ 14
3-28 Instruments and controls
when the outside temperature drops to
378F(38C) or lower again, unless the
outside temperature has increased to
418F(58C) or higher.
NOTE
The outside temperature indication
may differ from the actual outside
temperature. The road surface freeze
warning indication should be treated
only as a guide. Be sure to check the
condition of the road surface before
driving.
& Current fuel consumption (if
equipped)
This indication shows the rate of fuel
consumption at the present moment.
& Average fuel consumption
1) U.S.-spec. models
2) Except U.S.-spec. models
This indication shows the average rate of
fuel consumption since the trip meter was
last reset.
When either of the trip meter indications is
reset, the corresponding a verage fue l
consumption value is also reset.
NOTE
. The indicated values vary in accor-
dance with changes in the vehicles
running conditions. Also, the indicated
values m ay differ slightly from the
actual values and shoul d thus be
treated only as a guide.
. When either trip meter indication is
reset, the average fuel consumption
corresponding to that trip meter indica-
tion is not shown until the vehicle has
subsequently covered a distance of 1
mile (or 1 km).
& To turn off fuel consumption
indicator display
The fuel consumption indicator display
can be turned off.
To turn off this display, turn the ignition
switch to the LOCK position and press
the + button adjacent to the information
display for approximately 5 seconds.
Then, the information display an d the
clock display will blink for 3 seconds to
notify you that the fuel consumption dis-
play has been turned off.
To restore the indicator, once again press
the + button for approximately 5 sec-
onds.
NOTE
. The initial display setting of the fuel
consumption indicator of your vehicle
has been set to operational at the time
of shipment from the factory.
. The average fuel consumption is
calculated even while the indicator is
not displayed.
. Even if you turn off the fuel con-
sumption indicator, the fuel consump-
tion indicator will automatically turn on

Table of Contents

Other manuals for Subaru 2011 Forester

Related product manuals