Black plate (296,1)
北米Model "A8160BE-B" EDITED: 2010/ 10/ 14
7-32 Starting and operating
The Hill start assist system does not
operate when the vehicle is facing down-
hill. And the Hill start assist system may
not operate on slight grades.
When starting in reverse and using the Hill
start assist system, a braking effect may
be felt even after the brake pedal has
been released. However, this braking
effect should disappear once the clutch
pedal is released.
A slight jolt may be felt when the vehicle
begins to move forward after being re-
versed.
If the braking power of the Hill start assist
system is insufficient after the brake pedal
is released, apply more braking power by
pressing the brake pedal again.
& Hill start assist warning light
Refer to “ Hill start assist warning light (MT
models)” F3-21.
Cruise control
Cruise control enables you to maintain a
constant vehicle speed without holding
your foot on the accelerator pedal and it is
operative when the vehicle speed is 25
mph (40 km/h) or more. Make sure the
main switch is turned “OFF” when the
cruise cont rol is n ot i n use t o avoid
unintentionally setting the cruise control.
NOTE
If you press the main switch button
while turning the ignition switch “ON”,
the cruise control function is deacti-
vated and the cruise control indicator
light flashes. To reactivate the cruise
control function, turn the ignition
switch back to the “Acc” or “LOCK”
position, and then turn it again to the
“ON” position.
WARNING
Do not use the cruise control under
any of the following conditions. This
may cause loss of vehicle control.
. driving up or down a steep grade
. driving on slippery or winding
roads
. driving in heavy traffic
To Next Page
Loading...
