Subaru 2011 Forester - Bluetooth Setting

Black plate (238,1)
北米Model "A8160BE-B" EDITED: 2010/ 10/ 14
5-54 Audio
! Adjustable level of each volume
Volume Range Initial setting
Phone call 0 to 14 7
Voice 0 to 14 7
Voice guidance 0 to 6
3
& Bluetooth
®
setting
! Security setting
! Setting PIN code
The PIN code is a 4-digit number and is
used when locking the phonebook.
1. Select the “SET PI N” menu. Th en
“CURRENT PIN?” is displayed.
2. Input the current PIN code by operat-
ing the “TUNE/TRACK/CH” dial or saying
the number.
3. Select the “CONFIRM” menu.
4. Input the new PIN code by operating
the “TUNE/TRACK/CH ” dial or saying the
number.
5. Select the “CONFIRM” menu.
! Locking the phonebook
1. Select the “PHBK LOCK”/“PHONE-
BOOK LOCK” menu. Then “CURRENT
PIN?” is displayed.
2. Input the PIN code by operating the
“TUNE /TRA CK /C H” dial or sa ying the
number.
3. Select the “CONFIRM” menu. If the
inputted PIN code is correct, “LOCKED” is
displayed and the phonebook is locked.
NOTE
While the phonebook is locked, if the
operation restricted menu is selected,
“PHBK LOCK” is displayed.
! Unlocking the phonebook
1. Select the “PHBK UNLOCK”/“PHONE-
BOOK UNLOCK” menu. Then “CUR-
RENT PIN?” is displayed.
NOTE
If the phonebook is not locked, “UN-
LOCK” is displayed and the mode
changes to the security mode.
2. Input the PIN code by operating the
“TUNE /TRA CK /C H” dial or sa ying the
number.
3. Select the “CONFIRM” menu. If the
inputted PIN code is correct, “ UN-
LOCKED” is displayed and the phone-
book is unlocked.
! Phone setup
! Setting pair phone
Refer to “Preparation for using the Hands-
free system” F5-46.
! Selecting phone
To select the registered cell phone for
connecting to the in-vehicle equipment,
perform the following procedure.
1. Select the “SELECT PHONE” menu. If
no cell phones are registered, “EMPTY” is
displayed and the mode changes to the
“PHONE SETUP” mode.
2. Select the cell phone by operating the
“TUNE/TRACK/CH” dial or saying the
voice tag.
3. Select the “CONFIRM” menu (only
after saying the voice tag). “SELECTED”
is displayed, the selected cell phone is
connected to the in-vehicle equipment and
the mode changes to the “PHONE SET-
UP” mode.
! Changing the voice tag of the cell
phone
1. Select the “CHANGE NAME” menu. If
no cell phones are registered, “EMPTY” is
displayed and the mode changes to the
“PHONE SETUP” mode.
2. Select the cell phone by operating the
“TUNE/TRACK/CH” dial or saying the