Black plate (230,1)
北米Model "A8160BE-B" EDITED: 2010/ 10/ 14
5-46 Audio
used by a movable body identifi-
cation device.
& Using the Hands-free system
! Turning on/off the Hands-free mode
1) OFF hook switch
2) ON hook switch
3) Talk switch
To turn on the Hands-free mode, press the
OFF hook switch
. To turn off the
Hands-free mode, press the ON hook
switch
.
! Preparation for using the Hands-
free system
Before using the Hands-free system, it is
necessary to register a cell phone in the
system. Perform the following procedure
to register a cell phone.
1. Press the OFF hook switch
.
2. Select “ENGLISH”/“FRANÇAIS ” by
operating the “TUNE/TRACK/CH” dial.
Then “WELCOME!” will be displayed.
3. Press the “TUNE/TRACK/CH” dial or
the talk switch
.
4. Select the “RECORD NAME” menu.
5. Say the name to be registered.
6. Select the “CONFIRM” menu. After
“CAR M_MEDIA” is displayed, a pass key
is displayed.
7. Input the displayed pass key into the
cell phone whi le “PKY: ****” (type C
audio)/“PASS KEY: ****” (type D audio) is
displayed. If you input the correct pass
key, “PAIRED” is displayed and the
registration procedure is finished. If you
input an incorrect pass key, “FAILED” is
displayed and the registration procedure
was not successful.
NOTE
When the ignition switch is turned to
the “Acc” or “ON” position, the regis-
tered cell phones are automatically
connected to the system.
! Menu list of the Hands-free system
Turn the “TUNE/TRACK/CH” dial to select
a menu, and then press the dial to enter
the selected menu.
To Next Page
Loading...
