Black plate (198,1)
北米Model "A8160BE-B" EDITED: 2010/ 10/ 14
5-14 Audio
however, when radio signals are weak. In
such a situation, perform manual tuning to
select the desired station.
! Scan tuning (SCAN)
Type A and B audio
Type C audio
Type D audio
If you press the “SCAN ” button briefly
(type A, B and C audio)/continuously (type
D audio), the radio will switch to the scan
mode. In this mode, the radio scans
through the radio band until a station is
found. The radio will stop at the station for
5 seconds (type A, B and C audio)/10
seconds (type D audio) while displaying
the frequency, after which scanning will
continue until the entire band has been
scanned.
Press the “SCAN” button again to cancel
the S CAN mode and to stop at any
displayed channel.
Automatic tuning may not function prop-
erly if the station reception is weakened by
distance from the station or proximity to
tall buildings and hills.
! PTY (Program type) group tuning
(only FM reception)
Type A and B audio
Type C audio
Type D audio
Press the indicated button to change to
the PTY selection mode. At this time, the
PTY group that you are currently listening
to (type A, B and C audio)/that you
selected the last time (type D audio) will
be displayed for 10 seconds. In the PTY
selection mode, “PTY” is displayed on the
screen.
! PTY (Program type) group selection
In the PTY selection mode, press the
following button to change the PTY group
by one step at a time.
Type A and B audio:
PTY group up by
one step
PTY group down by
one step
Type C audio:
PTY group up by
one step
PTY group down by
one step
This operation only changes the display. It
does not change the station that is
currently being received.
! Seek in PTY (Program type) group
(type A, B and C audio)
Type A and B audio:
Seek up
Seek down
Type C audio:
Seek up
Seek down
To Next Page
Loading...
