3-26
Instruments and controls/Information display
corresponding to that trip meter dis-
play is not shown until the vehicle has
subsequently covered a distance of 1
mile (or 1 km).
! Current fuel consumption
1) U.S.-spec. models
2) Except U.S.-spec. models
This indication shows the rate of fuel
consumption at the present moment.
! Journey time
The journey time shows the time that has
elapsed since the ignition sw itch was
turned to the “ON” position.
The journey time indication flashes each
time a complete hour has elapsed. If the
display is giving a reading other than the
journey time, the display switches to the
journey time, flashes for 5 seconds, and
returns to its original reading each time a
complete hour has elapsed.
NOTE
The journey time is reset when the
ignition switch is turned to the “LOCK”
(off) position. It is also reset if the
ignition switch is turned to the “LOCK”
(off) or “ACC” position prior to restart-
ing of the engine.
! Average vehicle speed
1) U.S.-spec. models
2) Except U.S.-spec. models
This display shows the average vehicle
speed since the trip meter was last reset.
To Next Page
Loading...
