5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete.
& Image quality and volume
settings
The items in the image quality and volume
settings can be set. To change the items,
operate the “
” or “ ” switch.
! Preparation for image quality and
volume settings
1. Turn the ignition switch to the “ON”
position.
2. Pull and hold th e “
/SET” switch
toward you to show the selection screen.
3. After the selection screen is displayed,
operate the “
” or “ ” switch to show the
“Display” item. Then, pull the “
/SET”
switch toward you.
! Brightness setting
1. Perform the preparation steps accord-
ing to “Preparation for image quality and
volume settings” F3-47.
2. Operate the “ ” or “ ” switch to
select the “Brightness” item. Then pull the
“
/SET” switch toward you.
Instruments and controls/Multi function display
3-47
– CONTINUED –
To Next Page
Loading...
Need help?
General
