- 71 -
Rearview Camera Operations
11
Playing a Video through the Rearview
Camera
■ When the Camera Is Set to MANUAL or
AUTO
(1) Hold down the [SCREEN AV/NAV] knob.
This changes to the rearview camera screen.
■
When the Camera Is Set to AUTO
(1) Shift to the reverse gear.
This changes to the rearview camera screen.
ATTENTION
• The image field of view displayed on the
screen may vary depending on vehicle or
road surface conditions.
• The image field of view displayed on the
screen is limited; for example, you cannot
display something that is located near both
ends of the bumper or under the bumper.
• Colors shown in the rearward image may be
different from the actual colors of the objects
shown.
• In the following cases, Rearview Camera
vision may be reduced:
• In dark places ( at night, etc.)
• The temperature near the lens is high or low.
• When there are water drops on the camera, or
when humidity is high (during rain showers,
etc.)
• Foreign substances (mud, etc.) have become
attached to locations on or near the camera.
• The camera lens has been exposed directly to
sunlight or the rays of headlights.
• If a high-intensity point (sunlight reflected on
the vehicle body, etc.) is reflected on the
camera, it may result in a smearing
phenomenon
*
particular to the CCD camera.
* Smearing phenomenon: Refers to an image
lag that is caused in the vertical direction of a
high-intensity point (sunlight reflected on the
vehicle body, etc.) reflected on the camera.
<Screen Appearance>
Point of high-
intensity brightness
To Next Page
Loading...
Need help?
General
