Section 7
ILLUSTRATIONS AND PARTS LIST
38
7.4 MOTOR, FRAME, COMPRESSOR AND PARTS (LS---16 SERIES 60---75HP)
key part
number description number quantity
1 capscrew,hex 1/2”---13 x 1 1/2” 828608---150 2
2 motor, 60HP (230/460V) 250016---694 1
S
motor, 75HP (230/460V) 250016---695 1
3 support, motor 250017---492 1
4 nut, hex 3/8”---16 824206---337 12
5 washer, springlock 3/8” 837506---094 12
6 adapter, motor/compressor 250014---883 1
7 washer, springlock 5/8” 837510---156 24
8 capscrew, hex 5/8”---11 x 1 1/2” 828610---150 8
9 screw, hex serrated washer 829705---075 3
10 guard, coupling 250018---412 1
11 capscrew, ferry 5/8”---11 x 2 3/4” 828410---275 6
12 frame, main 250015---817 1
13 washer, conduit reducing 3” x 1 1/2” 847012---060 2
14 hub, coupling 250018---006 1
15 element, coupling (less hardware) 250018---551 1
16 hub, coupling 250018---007 1
1 7 c ompr essor unit
(I)
Consul t Fac tor y 1
18 capscrew, hex 3/8”---16 x 2 1/4” 828606---225 12
19 grip, cord #2 (75HP) 250014---559 2
S
grip, cord #2 (60HP) 250014---557 2
20 wire, type g---gc (75HP) 250014---308 4 ft.
S
wire, type g---gc (60HP) 250014---306 4 ft.
21 support, compressor 250017---491 1
22 capscrew, hex 5/8”---11 x 1 1/4” 828610---125 6
23 washer, 5/8” 837210---112 2
24 nut, hex 5/8”---11 824210---559 2
25 adapter, SAE flange 250016---611 1
(I)
There is an exchange program whereby a remanufactured compressor unit can be obtained from Sullair
distributors or the factory at less cost than the owner could repair the unit. For information regarding the
unit exchange program, contact your nearest Sullair representative or the Sullair Corporation.
The shaft seal is not considered part of the compressor unit in regard to the two year warranty, but the
normal Sullair parts warranty applies. Forshaft seal repairs, order shaft seal repair kit no. 02250050---364,
and seal tool kit no. 602542---001.
PLEASE NOTE: WHEN ORDERING PARTS, ALWAYS INDICATE SERIAL NUMBER OF COMPRESSOR.
To Next Page
Loading...
