Sun Microsystems GDM-FW9010 - Picture Tube Removal

GDM-FW9010(E) 1-8
1-8. PICTURE TUBE REMOVAL
GND
P5
P6
0 Picture tube
8 Anode cap
!™ Neck assembly
!¡ Deflection yoke
5 Bezel
3 Four screws
(Tapping screw 7 + crown washer)
4 Four screws
(+BVTP 4 x 16)
9 Four screws
(+BVTT 4 x 8)
1 Open the D block.
(Refer to 2-2.)
2 Open the G block.
(Refer to 2-3.)
6 A board
7 Three connectors
PROTECTION SHEET
NOTE: When replaced the picture tube,
stick the PROTECTION SHEET
(Part No. 4-036-700-01) on the
picture tube band.