setsmtp(8)
244 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised August 2009
OPTIONS The following options are supported:
EXAMPLES
EXAMPLE 1 Setting Up Mailserver and No Authentication in Noninteractive Mode
EXAMPLE 2 Setting Up Authentication in Noninteractive Mode
-h Displays usage statement.
When used with other options or operands, an error
occurs.
-s variable=value Sets SMTP.
Valid entries for variable are:
mailserver
port
auth
user
password
replyaddress
Where:
mailserver is specified by IP address or server name.
Server name, if specified, must be resolvable.
port is the port address for replies.
auth is the authentication mechanism. Valid values
are: none, pop, and smtp-auth.
user and password are for smtp mail service
authentication.
replyaddress is the address to which replies are sent.
This value can be specified in the format that complies
with Section 3.4.1 of RFC 5322.
-v Specifies verbose output.
XSCF> setsmtp -s mailserver=10.4.1.1 -s auth=none
XSCF> setsmtp -s auth=pop -s user=jsmith -s password=******
To Next Page
Loading...
