SUNBA Network Series - 10. Camera Configuration

- 19 -
Record: Set camera recording plan and mode. The “manual” and “st-
-op” selection allows you to manually turn on and off, and the “timing”
allows you to set the schedule where recording takes place.
Video Motion:
Enable motion detection alert formats (buzzer, email, recording, snapshot
& FTP etc), region, and sensitivity. Set motion detection video recording
time.
Video Blind:
Set an alarm when the vision of the camera is covered (usually by house
breakers using clothes).
Video Loss:
Set an alarm when a video loss happens.
Alarm Input:
External connection linkage alarms such as infrared sensor etc (not built-in
by camera, need additional support in qualied NVR).
Alarm Output:
Alarm output can be an external
lights, siren, etc. (not built-in by camera, need additional support in quali-
-ed NVR).
Abnormal:
Set an alarm for special events such as storage device access failure or IP
conict with other devices.