- 22 -
CURRENT LEVEL = Darkness of installation environment. The larger the
value, the darker the surrounding.
Turn on and off the IR LED manually. This can be accomplished using
special presets 100~103. Please check specialpreset.sunba.net
A.Auto Mode:
The infrared LED will be on automatically when photoresister of the
camera believes the neighboring environment is dark enough (reaches
the set threshold IR ON SENS).
LED ON SENS:
The threshold of photoresister to turn on the IR LED, default is 210.
LED OFF SENS:
The threshold of photoresister to turn off the IR LED, default is 185.
B.Manual Mode:
IR SETTING
IR MODE AUTO
IR ON SENS 210
IR OFF SENS 185
BACK EXIT
CURRENT LEVEL 33
NOTE: Unless you decide to turn the IR off permanently, the difference
between the LED ON and LED OFF values must be at least 30 to avoid
problems of IR LED blinking. PRESET 103+CALL to manually turn on both
sides together.
In Auto Mode, the camera will turn on and off IR LED automatically
according to the value of photoresister. If the value of the ambient
environment (CURRENT LEVEL) is≥the IR ON SENS, then the LED
will be turned on automatically, vice versa.
To Next Page
Loading...
