Sunbeam EMM7300 - Page 18

18
Troubleshooting guide
PROBLEM Possible cause What to do
Coffee grinds
are coarse
when on a fine
Grind Setting
Grind Setting not correct. Adjust the Grind Settings by turning the
Bean Hopper. See Tips for Grinding, &
Extraction.
Top Burr not seated correctly. Coffee
beans or grinds are caught around &
under the Top Burr.
Top burr needs removing and the areas
cleaning, before reinstalling.
Grinder Calibration needs resetting. See Grinder Recalibration.
Grind Setting
cannot be
adjusted
The Bean Hopper is not seated
correctly.
Remove the Bean Hopper & reinstall.
Coffee beans or grinds are caught
around the Top Burr or Grinder
Collar.
Remove the Bean Hopper & Top Burr.
Use the Cleaning Brush or Vacuum
Cleaner as necessary to clear loose
coffee beans or grinds.
Bean Hopper
cannot be
locked into
position
Grinder Collar not aligned to the Top
Cover.
Ensure markings on Top Cover and
Grinder are lined up.
Coffee beans or grinds are caught in
the Top Burr or Grinder Collar.
Remove the Bean Hopper & Top Burr.
Use the Cleaning Brush or Vacuum
Cleaner as necessary to clear loose
coffee beans or grinds.
The Top Burr is not seated correctly. Make sure the Top Burr is correctly
aligned and that the handle is folded
down.
Top Burr does
not sit in the
Grinder Collar
correctly
Coffee beans or grinds are caught
around & under the Top Burr.
Remove the Top Burr and replace the
Bean Hopper. Hold the Bean Hopper
down with your hand, do not turn. Insert
the Group Handle into the Grinding
Cradle and push down to activate the
Grinder. The coffee grinds will fall out
the Grind Outlet.
The Top Burr is not seated correctly. Make sure the Top Burr is correctly
aligned and that the handle is folded
down.
Grinder burrs
have small
spots and
marks
These are part of the hardening
process (for extra-long life). These
marks do not affect the performance
of the Grinder or the taste of the
espresso.
No action needed.