Functional Details 33
E500 Series Universal Low-Power Inverter
3: Special mode for terminal machine:
This function is only applicable to special occasions such as terminal machine.
X1
is used as the approach switch counting and stop signal, and X2 is start signal.
LED Hundreds: REV prevention
0: REV prevention void
1: REV prevention effective
LED Kilobit: Power-on auto start
0: Power-on auto start forbidden
1: Power-on auto start allowed
This parameter is the minimum output frequency allowed for the inverter. For
the functioning mode when it is lower than the lower limiting frequency, please
refer to parameter [F0.19].
It is used to define the velocity of increasing and decreasing of inverter’s output
frequency.
Acceleration time:
the time required for output frequency accelerating from
0.0Hz to the upper limiting frequency [F0.04].
Acceleration time: the time required for output frequency decelerating from
upper limiting frequency [F0.04] to 0.0Hz.
F0.03 Lower limiting frequency Setting range: 0.0 Hz ~ [F0.
F0.05 Acceleration time Setting range: 0.1 ~ 600.0Sec
F0.06 Deceleration time
Setting range: 0.1 ~ 600.0Sec
F0.04 Upper limiting frequency Setting range: [F0.3] ~ 400.0Hz
To Next Page
Loading...
Need help?
General
