53
step 4 Enter domain and peer port, and select remote signaling measuring point type, remote
signaling time mark, and upload with a change.
step 5 Click configuration
to import .xml file.
step 6 Click "Save".
-- -- EEnndd
9.10.11 MODBUS
Configure the MODBUforwarding service for the Logger3000 on this interface.
SSeerrvveerr MMooddee
In the server mode, Logger3000 is used as a Server and connected to PC server
through Modbus TCP protocol to implement data transmission and instruction delivery.
step 1 Click "System" -> "Transfer configuration" -> "MODBUS" to enter the corresponding
interface.
step 2 For the white list setting, refer to the description in "IEC104".
-- -- EEnndd
9.10.11.1 Client Mode
In the client mode, Logger3000 is used a Client and connected to PC server through
Modbus TCP protocol to implement data transmission and instruction delivery.
step 1 Click "System" -> "Transfer Configuration" -> "MODBUS" to enter the "Server" tab by
default.
step 2 Click "Client" to enter the corresponding tab.
step 3 Click "Add" to enter the "Advanced Settings" interface.
step 4 Enter domain and peer port and click "Save".
-- -- EEnndd
9.10.11.2 RTU Mode
In the RTU mode, Logger3000 is connected to PC server through Modbus RTU protocol
to implement data transmission and instruction delivery.
step 1 Click "System" -> "Transfer Configuration" -> "MODBUS" to enter the "Server" tab by
default.
step 2 Click "RTU" to enter the corresponding tab.
step 3 Select serial port and enter delay time.
step 4 Click
.
User Manual 9 Web Interface
To Next Page
Loading...
