Sungrow SG30CX - Table of Contents

TD_20210219_SG30-50-110CX Commissioning Guide_V1.1 Page 2 of 21
© SUNGROW AUSTRALIA GROUP PTY LTD All rights reserved.
As we continuously improving our products, changes to this document may occur without notice.
Contents
1 Introduction ......................................................................................................... 3
2 RS485 Connections ............................................................................................ 5
2.1 Inverter Connection (Daisy Chain) ................................................................ 5
2.2 Energy Meter Connection ............................................................................. 6
2.3 Connection to Logger1000 ............................................................................... 8
2.4 Connection via EyeM4 ...................................................................................... 9
3 Web Portal Setup ...............................................................................................11
3.1 Access Web Portal .......................................................................................11
3.2 Set local time ................................................................................................12
3.3 Scan for Inverters .........................................................................................13
3.4 Add Energy Meter ........................................................................................14
3.5 Enable Remote Control ................................................................................16
3.6 Internet Connection ......................................................................................17
3.6.1 Connect via Ethernet Cable (Logger1000 only) ........................................17
3.6.2 Connect via WiFi (Logger1000 and EyeM4C) ...........................................17
3.6.3 Connect via 4G (EyeM4A Only) ................................................................18
3.7 Add CT Transformation Ratio.......................................................................19
3.8 Setup Export Control if required ...................................................................19
4 Create Plant on iSolarCloud ...............................................................................20
5 Updating the Logger1000/EyeM4.......................................................................21