SunSetter EASYSHADE Owner’S Manual & Installation Instruction

13
APPENDIX B
Reset All Communicaons Between the Motor and Remote Transmier
 
 Press and Hold the my 
 
 
 
 
 Press and hold the Programmingten seconds, watching for two separate jogs back
and forth, several seconds apart
Note: A single jog is a quick two-direcon movement of the motor.
 Press and Hold the UP and DOWN 
Note: The EasyShade now moves ONLY while holding down the UP or DOWN buon.
Programming
Buon
Rear View
To ADD an 
• 

• 
To DELETE
Add/Delete a Remote Transmier
 Press the DOWN 

my
Press the DOWN 
DOWN
Front View
my
UP
Channel
Selector
Move the EasyShade to the desired UP 
Press and Hold the my and DOWN 

Press the my Stop the EasyShade at the desired Down
Make desired adjustments to the Down
Press and Hold the my and UP 
begins to move UpLet the EasyShade stop on its own at the UP 
Press and Hold the my
Up and
Down
17. Press and Hold the Programming buon, wait for jog
Up and Down
SET PROPER DIRECTION OF MOTOR ROTATION
PREPARE MOTOR - See Figures 25 & 26
SET THE UP AND DOWN POSITIONS
WARNING: ALL STEPS MUST BE FOLLOWED EXACTLY AND COMPLETELY



This procedure overwrites the factory set Up and DownUp and Down
Note: To ONLY change the Up and Down preset posions, follow the basic procedure in Appendix A.
Tools needed: A pen or similar poinng device is needed to press and hold the Programming Buon.
Note: If steps 8-15 fail, unplug the Power, plug back in, then begin again from step 8. If
that fails to help, go to Advanced Motor Troubleshoong on Page 11.
Figure 25
Figure 26

SunSetter EASYSHADE Specifications

General

Brand	SunSetter
Model	EASYSHADE
Category	Accessories
Language	English