SunSetter EASYSHADE - OPERATION AND PROGRAMMING CONTINUED; Operation Problems; Reprogramming Motor

11
TROUBLESHOOTING
Operaon (connued)
ADDITIONAL MOTOR TROUBLESHOOTING
Problems:


1

or
EasyShade / Motor only runs while holding down the UP or DOWN
Soluon:
 
 Wait two seconds,
 Plug in Motor,
 If the Motor DOES jog, go to Group A
 If the Motor DOES NOT jog, go to Group B
GROUP A GROUP B
 Press and Hold the UP and DOWN

 
 Press and Hold the PROGRAMMING
 
 
 Press and Hold the UP and DOWN

 
 Perform Steps 9 - 18 in Appendix B
 
If GROUP A or B (above) does not x the problem, then . . .
Perform Steps 1 - 18 in Appendix B, or call Technical Support 800-670-7071
1
Self Test the Remote Transmier;
 Up, Down, my
 
 
 
 CR2430