14
APPENDIX C
PROGRAMMING INSTRUCTIONS - MULTI CHANNEL REMOTE TRANSMITTER
Note: Each EasyShade operates on Channel 1 of the Remote that came with it.
Every Channel on every Remote Transmier is dierent, but you can mix and match them.
Channel
Selector
Channel
Indicator
Lights
my/STOP
Figure 27
How to use the Mul Channel Remote Transmier (see Figure 27):
• To idenfy the currently selected Channel, press and release the Channel
• To select the next Channel
How to program the EasyShade to work with any Channel (see Figures 28, 29 & 30):
One EasyShade can
See Figure 28
Add each Channel to
the EasyShade, using
STEP 1, then STEP 2 in
Figure 30
One Channel can
Figure 29
Add that Channel
to each EasyShade,
using STEP 1, then
STEP 2 in Figure 30
be removed from an
EasyShade using STEP 1,
then STEP 2 in Figure 30.
Programming
Figure 30
STEP 1
Select a Channel that
currently controls
the EasyShade being
Hold the Programming
Note: It is recommended all EasyShades be unplugged from the power source except for the
one EasyShade being programmed. This simplies the process and reduces errors.
STEP 2
Select a Channel to
the EasyShade being
Hold the Programming
Programming
Figure 28 Figure 29
To Next Page
Loading...
Need help?
General
