SunSetter EASYSHADE - TROUBLESHOOTING - INSTALLATION AND APPEARANCE; Installation Not Functioning; Appearance Issues

9
Appearance
Problem Soluon
Fabric rolls up unevenly or
pulls to one side when the
Motorized EasyShade is

 

 
Both the Aluminum Housing and the Cable Brackets must be installed on




Short lines appear in the





Fabric appears folded or
pleated as it extends from




 

 
where the Aluminum Leading Bar is located, is just below the opening of

Operaon
Problem Soluon

to Open or Close the


be set to Channel 1

 
 Channel 1


CR2430
 
Page 11




the red light on the Remote




1. Remove and replace the Remote Transmier’s Baery with a new Lithium
CR2430
 
 Remove back cover,
 
 
 
 Remove the back cover to allow it to dry out completely,
 
Note
TROUBLESHOOTING