SunSetter EASYSHADE - INSTALLATION - SOLAR PANEL AND MOUNTING; Attach Solar Panel to Housing; Mount Housing and Vertical Brackets

3
Aluminum
Housing
for the
EasyShade
Assembly

Set Screw


Surface


Round
Head
Screw
Figure 3

Bracket
Protruding


Recessed

of the
EasyShade
Assembly
INSTALLATION
MOUNT EASYSHADE

HOUSING TO HOUSE
1



INSTALL VERTICAL MOUNTING BRACKET
2aVercal Surface

Note the orientaon of the Bracket; the end with the

See Figure 3
2b
(Horizontal Surface)
Note the orientaon
of the Bracket; the end with the Set Screw should

See Figure 4

Figure 4
Set
Screw

Round
Head
Screw

Bracket
Protruding

Top Groove
of Housing
EasyShade
Aluminum
Housing
Recessed

EasyShade
Assembly
House
INSTALL HORIZONTAL MOUNTING BRACKET
Set Screw
Recessed Area

Bracket
EasyShade
Housing
Figure 5
3
Figure 3 and 4
While maintaining upward pressure to keep the Top Groove of the EasyShade Assembly on the Tab of the

Figure 5
INSTALL EASYSHADE

INTO BRACKETS
Note: Aluminum Housing and Cable Brackets need to be mounted on the same Vercal Surface. If mounted
to siding, it may be necessary to shim the Brackets to create a at mounng surface.