SunStar Fortuna 5 Series - Page 58

No. Function
53 Cliange between Bf\ and swildi with buttons A or B dumg sewing
54 Selection of button A function
Inittal value Range
1= Selecl with button B
55 Selection of Buttons function
56 Selection of speed during manual back tack during sewing
57 NOT USED
58 Thread Trimming Sequence Selection of SunStar Chain Stitch Machine
59 Thread Trimming Sequence Selection of otiier Company ctiain Stitch Machine
60 Selection of re verse rotation after trimming
61 Reverse ro tation instance wtien selecting reverse rotation after ttiread trimming
62 V\4ten machine stops fix pulley (\Mien madiine slops fix the mctof by fc «!e)
63 Power to fix the A number 62 Pulley
64 Distance recovered after fixing A number 62 Pulley and rotating It by force
65 Select the motor rotating (jrectionf |°[—| j
aocia»«ftoufllefciociw>i5e
66 Target speed: If tilis speed is reached or passed, a signal saying
Target speed has been reached" will awwar.
(As an Interior Port It is alloted and used in the 'C GROUP-DefaiJt is auxSiary)
67 Delay start setL4}
68 Delay start ti me duration setup
69 Setup of needle bar's stop at the lowest position after trimrrting when the
pedal is pressed
70 Setup of the duration of needle bar's stop at the lowest position ^er
trimming w^n the pedal pressed
71>75 Not Used
76 Setting pattern sewing extension
77 Automatic changes of twin needles
78 Start Backtack ON Duration
79 Start Backtack OFF Duration
80 End Backtack ON Duration
81 End Baddack OFF Duration
82 Stitch width reduction during backtacking
Not Used
84-87 Not Used
88 Automatic PF lilt aid left/ri^t needle solenoid fift
En^disable die solenoid OFF fi jncBon after majntah
89 Upon trimming for a chain4ype model, enable/d^ble the needle auto fifl
0
40
20degree
lOOOspm I 40-9960
0: Only BT operates
1: Uft and drop needle plate with one movement
2: Lift neede plate with one movement
[^p needle plate i#i two movements
3: Slow performance when stopped
(1/2 stitch speed)
0: BT delete insertion
1 :Uftand drop needle jiiate with one movement
2: Slow performance when stof^
(1/2 stitch speed)
3: Only B/T operates
0/1 0: current sewing speed
liirvtic^ reverse sp^
1 iselection of reverse cirection
1 degree
1: fix when machine stops
1
1 degree
lidockwise
0: couiterciockwise
405pm
O=notmal start
1=Delay start
1xlO(^ms]
0=disabled
1=enabled
11ms]
Q/t 0: No pattern extension
1: Pattern extension
0/1 0: Teach stitch not used
1 : Teach stitch used
4~1020[ms]
4-1020(ms]
. (Parameter run when the Backtack
4-m24{msj accuracy function is used)
4-1020{ms]
0/1 0=disabled
1=enabled
0; Enable(in Ihe everrt of an electnyic solenoid)
1 lOisatfefn the everrt of usaig a pneunaic solenoid)
~ I CNJisabled
1=enal:^ed
A
If the specie Items of the parameter are changed carelessly, ^ey could break down or damage the machine, so the
user must be well-trained before using It
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com