14
[Fig. 5]
[Fig. 6]
④
④
①
①
②
②
③
③
E. Table leg holder
▶ Method
ⓐ Loosening the nut ① and turn and raise the label adjuster ② until the caster ③ is raced.
ⓑ After installation, fasten the nut ① and fix the label adjuster ②.
ⓒ With the bolt ④, adjust the height of table by loosening 8 different spots.
[ Caution ]
For safety, work with the power cut off.
F. How to attach the accessories for air pressure control.
ⓐ Connect air hose ② to quick joint socket ①.
ⓑ Connect quick joint socket ① and quick joint plug ③.
ⓒ Open finger valve ④ and flow air in. Then, adjust the air pressure to
5~5.5kgf/㎠(0.49~0.54MPa)
.
[ Caution ]
When the air pressure goes down (under 4kgf/㎠), an error is indicated and the machine operation is stopped.
Error message : Err 24 (Low Pressure !)
[Note] When the finger valve ④ is closed after use, the remaining air is rejected and the pressure
is adjusted to 0Mpa(0kgf/㎠ ).
To Next Page
Loading...
