Page | 11
ALSO CONSIDER:
Installing the indoor unit, outdoor unit, power supply cable, transmission cable, and
remote control cable at least 1 metre away from any television or radio receiver. This
will prevent TV reception interference or radio noise. This will prevent radio signal
interference from external units that might interfere with the Wi-Fi or GSM monitoring.
If children under 10 years old may approach the unit, take preventive measures so that
they cannot reach and touch the unit.
Install the indoor unit on the wall where the height from the floors is higher than
1600mm.
For proper heat dissipation, allow a clearance of approximately 500mm to the side,
500mm above nd below the unit, and 1000mm to the front of the unit.
4.2. Mounting the Inverter
An appropriate ambient temperature is between -25 ~ 60°C to ensure optimal operation.
Be sure to keep other objects and surfaces as shown in the figure to guarantee sufficient
heat dissipation and have enough space to remove wires.
For proper air circulation to dissipate heat, allow a clearance of approximately 50cm to
the side.
To Next Page
Loading...
Need help?
General