86
1) Set stoppers in front and behind the crawlers.
2) Put a chain or wire rope over the lower frame and
the foreside devices and fasten them securely.
5.5 Transportation on highway
You must understand and obey the local regulations
before transporting the machine on highway.
1) Check the trailer’s length, width, height and weight
before transportation by trailer.
2) Check the road condition before transportation, such as limit of size，weight and transportation
rules.
Sometimes the machine needs to be disassembled to fit the size or weight limits.
5.6 STOREAGE
Long-term storage of machine
While storing the machine, retract the cylinder piston rod to the inside of cylinder as much as
possible to avoid piston rod corrosion caused by rain and wind, clean machine surface and all the
exposed parts.
Machine handling before storage
(1) Grease the parts that need lubrication until fresh grease runs out.
(2) Change engine oil.
(3) Grease the exposed surface of piston rod.
(4) Fill in diesel oil to the fuel oil tank to the full.
(5) Choose a proper storage place：It’s best to store the machine in a room, if it can only be
stored outdoors, you should choose a flat ground and cover the machine with cloth.
Machine storage period
(1) Run the machine once a month during storage period.
(2) Run the air-conditioner system once a month.
Machine handling after storage
(1) Wipe the grease off on piston rod surface.
(2) Grease all the places that need lubrication.
(3) Check engine oil level to make sure it is in a stipulated position, otherwise you should
fill oil. If there is any water in oil, change oil
(4) Turn the key to “ON” position, switch accelerograph button from low to high speed and
last for 3 seconds, then switch to low speed and start engine.
FIG.5-3
To Next Page
Loading...
