SUNWARD SWE215F-5 - Safety Rules During Traveling; Traveling on Slopes

OPERATION & MAINTENANCE MANUAL SWE215F
28
 When traveling, swing, operating working device in
confined area, position a signal person and define the
meaning of the signals beforehand.
1.3.11 Safety Rules during Traveling
 During operation of machine, do not operate
exceeding max load capacity or performance to avoid
stall and damage to working device.
 When traveling on flat ground, fold the working
device and keep 400 to 500mm high above the ground.
 When traveling on rough ground, travel at low speed.
Do not steer sharply， there is a risk of machine
turning over. The work device may hit the ground and
cause machine to lose its balance or damage the
machine or structures.
 When traveling on rough ground or on slope, disable
the auto-reduction switch( if present) ， if
auto-reduction switch is on, engine revs may increase.
This may cause machine to speed up abruptly.
 Avoid traveling on obstacles if possible. if the machine
has to travel on obstacles, lower the working device
close to the ground at low speed. Do not travel over
obstacles which involve risk of tilting machine to one
side.
 When traveling or operating, keep a safe distance from
people, structure or other machine to avoid making
contact with them.
 When passing over bridges or structures, check first
structure is strong enough to support the weight of the
machine. When traveling on road, contact relevant
authorities and follow there instructions.
 When operating in tunnel, under bridges, under
electric wires or other height-limited area, operate
slowly and pay much attention not to hit anything.
1.3.12 Traveling on Slopes
To prevent machine from tipping over or side sliding,
follow the instructions below.
 When travel on slopes, keep working equipments 20
to 30cm high above ground. In case of emergency,
lower the working device to ground to help stop the