SUNWARD SWE215F-5 - Attachments; Maintenance Precaution of Track Tension Mechanism; Safety Rules for High-Pressure Oil

OPERATION & MAINTENANCE MANUAL SWE215F
34
least 15 minutes for volatilization prior to welding or
heating.
1.4.9 Attachments
There are some hazards that those stored accessories say
bucket, breakout hammer might fall off to cause serious
injury.
 Store accessories and equipment to avoid falling off.
Take necessary measures to prevent children and
unauthorized personnel from entering storage area.
1.4.10 Maintenance Precaution of Track Tension
Mechanism
 Grease is being pumped into track tension adjustment
system under high pressure. During adjustment operation,
if the specified maintenance procedures are not followed,
the lubricating grease drain plug (1) may fly out leading
to serious injury and damage.
 When loosening grease drain plug (1) to loosen the track
tension. Never loosen it more than one turn. Loosen the
grease drain plug slowly.
 Never put your face, hands, feet, or any other part of
your body close to grease drain plug (1).
 Recoil spring assembly contains a compression spring
which serves as a shock absorber for the idler. If it is
disassembled improperly, spring may fly out and cause
serious injury and even death. Do not disassembly
recoil springs.
1.4.11 Safety Rules for High-pressure Oil
 Hydraulic system is always under internal pressure.
When inspecting or replacing piping or hoses, always
check that the pressure in the hydraulic circuit has
been released. If the circuit is still under pressure, it
will lead to serious injury, so always do as follow.
 Never attempt any inspection or replacing operation
if hydraulic system is under pressure.
 If there is any leakage from piping or hoses, the
surrounding area is wet, so check for cracks or
swelling in the hoses. When carrying out inspection,
wear goggles and leather gloves.