OPERATION & MAINTENANCE MANUAL SWE215F
route or means of transportation according to the
width, height or weight of the load.
Provide proper truck or trailer for road transportation.
When crossing bridges or private structures, check
first to ensure that the ground is firm enough and
capable of supporting the weight of the machine.
When the machine has to travel on road, it’s necessary
to contact relevant authorities to follow their
instructions.
For any instructions concerning loading or unloading
machine, refer to the chapter 2 (transportation and
storage).
1.3.15 Parking Machine
Parking machine on a firm, level ground.
Select a place without hazard of falling rocks or
landslides, or flooding.
Lower the working devices completely to the ground.
When leaving machine, place the pilot safety lever to
LOCK position, and then stop the machine.
To prevent unauthorized person from operating the
machine, always close the cab door, use the key to
lock all the equipment. Then remove the key, and keep
the key with you, and leave the key in a prescriptive
place.
If the machine has to park on slopes, follow the
instruction below：
◆ place the bucket to the downhill side, then dig it into
the ground.
◆chock the track to prevent machine from moving.
1.4 SAFETY MAINTENANCE INFORMATION
1.4.1 Using Warning Signs
Warning: During maintenance or service
procedure, any attempt to start the engine, have access
or operate control lever of working device can result in
serious injury or damage.
Always post “DO NOT OPERATE” tag to the control
To Next Page
Loading...
