SUNWARD SWE215F-5 - Parking Machine Prior to Maintenance; Safety Maintenance Rules

OPERATION & MAINTENANCE MANUAL SWE215F
31
lever in the cab to alert the other person that you are
carrying out maintenance or service.
 Set the other warning signs around the machine if
necessary.
1.4.2 Parking Machine Prior to Maintenance
 Park the machine on firm level ground.
 Lower the bucket to the ground.
 Switch off the idle, run the machine at low speed for 5
minutes.
Set the key switch to OFF position to stop the engine.
 Operate each control lever, release internal pressure of
hydraulic system.
 Remove the key from the switch, set the pilot lock
lever to LOCK position.
 Post “DO NOT OPERATE” sign to the controls.
 Cool the engine.
 Chock the track to prevent machine from moving.
1.4.3 Safety Maintenance Rules
 Understand all maintenance instructions prior to
operation.
 Keep the working site clean and dry.
 Do not spay water and vapor in cab.
 When the machine if moving, do not lubricate the
machine or perform any maintenance operation.
 Prevent any parts of the body from reaching moving
parts of the machine.
 If the maintenance procedure has to be carried out
when engine is running. Position a person in operator
seat to stop the engine at any moment. All persons
keep each other in touch.
 Do not operate under the machine which is supported
by boom. If you have to service the machine with
boom supported, use bracket or block strong enough
to support the machine and working device securely.
 Dispose of replaced parts in time; remove any