99
5.5.4.1 Check and Adjust Track Tension
For detail, please refer to chapter 5.5.3.4.
5.5.4.2 Drain Water and Deposit From Water Separator
For detail, please refer to chapter 5.5.2.2.
5.5.5 Every 100 Hours
Carry out the maintenance for every 50 hours service at the same time.
5.5.5.1 Check and adjust fan belt tension
For detail, please refer to chapter 5.5.2.7.
5.5.6 Every 250 hours
Carry out 50 hours service at the same time.
5.5.6.1 Checking swing redactor gear oil level
Stop the machine at level ground.
Shut auto-idling switch to run the engine unloaded at low
temperature for 5 minutes.
【Important】
Stopping the engine improperly may damage
turbocharger.
Set start key to OFF position, stop the engine, remove the
key from starting lock, set safety lock lever to LOCK
position.
Note
After completing work, the gear oil temperature might be
very high, wait for temperature to cool down.
Pull out dipstick of swing redactor, wipe off oil trace,
reinsert it and pull out again, the oil mark should be
between the two scales.
If necessary, remove oil fill cap to add gear lubricating oil.
Check oil level again.
To Next Page
Loading...
