hand to prevent pressured oil shooting up causing injury.
Tighten, repair, or replace any clamps, pipe, hose, oil cooler, and flange bolt of oil cooler.
Don‘t twist or knock on high-pressured pipe.
Don‘t assemble twisted or damaged pipeline or hose.
Inspect short circuit. The short circuit of electric system can cause fire.
Before every shift or 8 hours operation, check loosened, twisted, hardened, or cracked cable and wire.
Before every shift or 8 hours operation, check lost or damaged connectors.
Before operation, tighten, repair, or replace any loosened or damaged cable, wire and connector. If the cable or
wire is loosened or twisted, don‘t operate the machine.
Repair switch
Before everyday operation, check the function of key switch and engine emergency stop switch. If there is any
unusuality, must repair at once. In case of fire, if you can‘t stop engine, it will aggravate firepower, and may
cause GBH.
Clean out inflammable materials
Spilled fuel, stored breeze, and other inflammable materials, may cause
fire. Keep the machine clean every day to prevent fire.
1.37 EMERGENCY EXIT
Emergency exit mark (As figure 1.35.1):
When there is an emergency and the operator can not get out of the cabin, take the small hammer (As figure
1.35.2) hung on the wall in cabin to break the window with emergency exit mark to leave the machine. The
cabin safety structure can not be repaired after damage but it can be replaced with other qualified safety
protective structures.
(1) Pay attention not to be hurt by the splashing objects while breaking the
window with a certain distance to the breaking hole for safety.
(2) The breaking hole should be big enough for operator to get out
(according to operator’s own condition) and the hole should have no
sharp spines for safety.
To Next Page
Loading...
