52
Heating Operation
At first, the hot water valve must be opened, then do according ―aeration operation‖.
Special Operation
①. Strong refrigeration operation
When it is very hot, especially a period of time after just turning on the air conditioner, you should choose this
operation. That is: choose refrigeration pattern, press ―wind speed increasing button‖ to choose the highest
wind speed, press ―set increasing button‖ to choose the lowest temperature.
②. Weak refrigeration operation
When it is slightly hot, especially the period of time after turning on air conditioner, the indoor temperature is
suitable or even a little cool, you should choose this operation. That is: choose refrigeration pattern, press
―wind speed decreasing button‖ to choose the lowest wind speed, press ―set decreasing button‖ to choose the
highest temperature.
③. Strong heating operation
When it is very cold, especially the period of time after just turning on the heater, it is cold inside the vehicle
or sometimes there is frost, snow which needs removing, you should choose this operation. That is: choose
heating pattern, press ―wind speed increasing button‖ to choose the highest wind speed, press ―set increasing
button‖ to choose the highest temperature.
④. Weak heating operation
When it is slightly cold, especially the period of time after turning on the heater, the indoor temperature is
suitable or slightly warm, you should choose this operation. That is: choose heating pattern, press ―wind speed
decreasing button‖ to choose the lowest wind speed, press ―set decreasing button‖ to choose moderately low
temperature.
⑤. Dehumidification and defrosting operation
When it is damp (including the indoor vapor and sweat made by human) and indoor temperature is higher than
outdoor (including using heater), except the discomfort of dampness to human, a layer of frost will form on the
inner side of the glass which will affect the view. Now you should choose this operation.
There are two ways of this operation:
To Next Page
Loading...
