80
5.4.9.2 Exhaust Temperature Warming Light
ON: When Reset or Recovery Regeneration is actived.
5.4.9.3 Regeneration Permitted Indicator Light
1Hz: When Reset Regeneration is active, and the DPF
Regeneration Disable Switch (REGMSW) is inhibited and
engine warming is done.
1Hz: When standby of Stationary EM mode or Recovery
Regeneration is active, interlock is permitted and engine
warming is done, engine rev is at low idle speed.( press
regerneration switch to begin)
1Hz: When the standby of Stationary Allow mode and interlock
switch is permitted, regeneration prohibit switch is
permitted and engine warming is done, engine rev is at low
idle speed.( press regerneration switch to begin).
1Hz: When 50hr passed after Reset or Stationary or
Recovery Regeneration, and the REGMSW is
inhibited, and interlock switch is permitted, engine
warming is done.
ON: When stationary regeneration or recovery regeneration is
active or press regeneration request switch.
5.4.9.4 Engine Fault Light
ON: When standby of Stationary EM mode is active or clear dust
or engine is at standby mode.
ON: When there's other problems occur.
5.4.9.5 Regeneration Request Switch
Standby regeneration request switch is only used when standby
regeneration request lamp is lighting( engine can not
automatically regeneration).
5.4.9.6 Interlock Switch
When it is on the stationary regeneration, it must first to use
regenerated interlock switch to lock hydraulic system when the
engine can not be regenerated.
To Next Page
Loading...
