Release : 1.1f 147 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
Adding Stacking Members
Connect the stacked switches using stacking cables. For better redundancy, connect the
switches as a daisy chain as shown in the diagram below. This chain connectivity helps to
maintain stacking in the case of a single link or switch failure.
Before connecting switches in stacking make sure stacking is enabled in all switches and
that switch identifiers and priorities are configured properly.
There is no specific configuration required to add stack switches. If two stacking enabled
switches connected through stacking cables, they form the stack.
Do not use the same switch id for multiple switches on the stack.
Only one master switch user is allowed to configure a stack. The slave switches
will not allow you to configure anything except stacking disabled. To login to
slave switches, use a login name such as “stackuser” and a password like
“stack123”.
To Next Page
Loading...
