Release : 1.1f 148 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
Removing a stacked switch
To remove a switch from stacking follow the below recommended procedure:
1. Disconnect stacking cables.
2. Reboot the removed switch as a stand-alone switch.
3. Execute “no stack” command.
4. Reboot the switch again to operate as regular stand-alone switch.
When a switch is moved from stacking to stand-alone mode, the saved stacking
configurations can not loaded in stand alone mode. When the “no stack”
command is issued, the switch software will rename the existing configuration file
to avoid automatic restoration of stacking configurations on a stand-alone switch.
To Next Page
Loading...
