Supermicro Supero C7Z97-M - Clear CMOS (JBT1), (S8)

Chapter 2: Installation
2-29
JTPM1
JIPMB1
S4
I-SATA3
I-SATA0
I-SATA1
JPL1
JPUSB1
JLED1
JVR2
JVR1
JPG1
JPAC1
JBT1
JSTBY1
JSD1
JF1
Rev. 1.00
BIOS
LICENSE
FOR HOME OR OFFICE USE
With FCC Standards Tested to Comply
JPW2
JL1
JL2
JI2C1
JSPDIF_OUT
JPW1
MAC CODE
BAR CODE
JITP1
LEDM1
SP1
FAN3
FAN2
FAN4
FAN1
FAN5
JD1
JAUDIO1
JBR1
USB8/9(3.0)
OC_FRONT_PANEL
(3.0)
I-SATA0
I-SATA1
I-SATA2
I-SATA3
I-SATA4
I-SATA5
(3.0)
USB 2/3
USB 12/13
FAN1/CPU
PCH_SLOT2 PCI-E 2.0 X4
LAN
HDMI/DP
KB/MOUSE
AUDIO FP
DIMMB1
DIMMB2
HD AUDIO
USB4/5
USB6/7
DIMMA1
DIMMA2
CPU_SLOT1 PCI-E 3.0 X8
CPU_SLOT3 PCI-E 3.0 X16
COM1
VGA(IPMI)
USB 0/1
JI2C2
C7Z97-M
JPME2
JWD1
S8
S11
D
Clear CMOS (JBT1), (S8)
JBT1 and the S8 Button is used to clear the saved system setup congu-
ration stored in the CMOS chip. For JBT1, to clear the contents of the
CMOS, completely shut down the system, remove the AC power cord and
then short JBT1 with a metallic object such as a screwdriver. For the S8
Button, shut off the system and press this button.
Any of these two will erase all user settings and revert everything to
their factory-set defaults.
Note: On the C7Z97-MF, the boot time immediately after clearing the
CMOS may take longer due to additonal IPMI functions.
A. Clear CMOS
B. JI
2
C1
C. JI
2
C2
D. Clear CMOS Button
PCI Slot_SMB Enable
Jumper Settings
Jumper Setting Denition
Short Enabled
Open (Default) Disabled
PCI Slot SMB Enable (I
2
C1/I
2
C2)
Use Jumpers I
2
C1/I
2
C2 to enable PCI
SMB (System Management Bus) support
to improve system management for the
PCI slots. See the table on the right for
jumper settings.
C
A
B