Supermicro Supero X9SRH-7F - Page 114

C-4
X9SRH Motherboard Series User’s Manual
8. When a DOS prompt appears, type AMI.BAT BIOSname.### at the prompt.
Note: Do not interruptthisprocessuntilBIOSashingiscompleted.
9. After seeing the message that BIOS update is completed, unplug the AC
power cable to clear CMOS, and then plug in the AC power cable to power
on the system.
10. Press<Del>continuouslytoentertheBIOSSetuputility.
11. Press<F3>toloaddefaultsettings.
12. Afterloadingdefaultsettings,press<F4>tosavethesettingsandexitthe
BIOS Setup utility.