Supermicro Supero X9SRH-7F - How to Start the Setup Utility

4-2
X9SRH Motherboard Series User’s Manual
HowToChangetheCongurationData
Thecongurationdatathatdeterminesthesystemparametersmaybechangedby
entering the AMI BIOS Setup utility. This Setup utility can be accessed by pressing
<Del>attheappropriatetimeduringsystemboot.
How to Start the Setup Utility
Normally, the only visible Power-On Self-Test (POST) routine is the memory test.
Asthememoryisbeingtested,pressthe<Delete>keytoenterthemainmenuof
the AMI BIOS Setup Utility. From the main menu, you can access the other setup
screens.AnAMIBIOSidenticationstringisdisplayedattheleftbottomcornerof
the screen, below the copyright message.
Warning! Do not upgrade the BIOS unless your system has a BIOS-related issue.
Flashing the wrong BIOS can cause irreparable damage to the system. In no event
shall Supermicro be liable for direct, indirect, special, incidental, or consequential
damages arising from a BIOS update. If you have to update the BIOS, do not shut
down or reset the system while the BIOS is updating. This is to avoid possible
boot failure.