Supermicro SuperServer 2029TP-HC0R - Page 51

SuperServer 2029TP-HTR/HC1R/HC0R User's Manual
51
Installing Expansion Cards
1. Use the control panel to power down the computing node, and pull the node drawer out
of the chassis.
2. Open the PCI slot clip in the rear of the node drawer and remove the PCI slot shield.
3. If the riser card is not already installed, push it into the motherboard slot.
4. 
opening in the rear of the node drawer.
5. Close the PCI slot clip to secure the expansion card shield.
6. Secure the riser card screw.
7. Return the node drawer and power-up.
Figure 3-11. Installing the Expansion Card
Riser Card
Riser Card
Bracket
PCI Slot
Shield
Expander Card
Note: Figure is for illustrative purposes only. Your system may or may not resemble this
picture.