Supermicro SuperServer 2029TP-HC0R - Installing the Riser Card

50
Chapter 3: Maintenance and Component Installation
Installing the Riser Card
Installing the Riser Card
1. Use the control panel to power down the computing node, and pull the node drawer out
of the chassis.
2. Remove the riser card bracket, removing the screw on the back of the drawer.
3. 󰀨
the bracket using the two screws included in the accessory box.
4. Insert the riser card into the slot on the motherboard.
5. Secure the riser bracket to the rear of the node drawer.
Figure 3-10. Installing the Riser Card