Supermicro SuperServer SYS-221H-TNR - Installing the PHM into the CPU Socket

46
Chapter 3: Maintenance and Component Installation
a
b
d
c
(a, b, c, d: Threaded Fasteners)
CPU Socket Pin1
CPU Socket
Installing the PHM into the CPU Socket
After assembling the Processor Heatsink Module, you are ready to install it into the CPU
socket. To ensure proper installation, please follow the procedures below:
1. Locate four threaded fasteners (a, b, c, d) on the CPU socket.
2. Locate four PEEK nuts (A, B, C, D) and four rotating wires (1, 2, 3, 4) on the heatsink
as shown in the graphics below.
Mount the Processor Heatsink Module ontot the CPU socket (on the motherboard)
A, B, C, D: Peek Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
Peek Nut
(Unlatched)
(Latched)
Rotating Wire
a
c
b
d
C
A
D
B
Rotating Wire 1
Rotating Wire 3
Rotating Wire 4
Rotating Wire 2
Peek Nut
Heatsink (Reverse Side)
CPU Socket